Decorative & Custom
Decorative and custom finishes
Hand-applied wall finishes with depth and movement — the surfaces that give a room its character rather than just its colour.
- Free Quotes
- Residential & Commercial
- Local Melbourne Painters
What are decorative and custom finishes?
Decorative finishes are wall and surface treatments applied by hand in multiple layers to create depth, texture and movement that a single coat of paint cannot produce. Venetian plaster, limewash, concrete-look and metallic systems all fall into this category: the appearance comes from the material and how it is worked, not from a colour printed on a chart.
Overview
A decorative finish is applied, not simply rolled on. Venetian plaster is burnished in layers; a concrete-look finish is built up and worked back; a metallic is laid off in a direction that catches light across the wall. The result has depth that a flat colour cannot produce.
This is specialist work and it is slower than standard painting. It suits feature walls, entries, stairwells, powder rooms and joinery surrounds — places where one surface is meant to carry a room.
Every finish below is sampled before it goes on a wall. Decorative work is impossible to judge from a photograph, because it changes with the light in the actual space.
Summary
At a glance
- Service
- Decorative & Custom Finishes — Venetian plaster, concrete-look, faux and metallic finishes, and hand-painted feature work.
- Suitable for
- Feature walls, entries, joinery and commercial interiors where a flat painted finish is not the intended result.
- Surfaces and systems
- Lime and acrylic-based polished plasters, Micro-cement and concrete-effect systems, Metallic, pearlescent and glaze coatings, Textured and trowel-applied plaster systems and Protective sealers appropriate to each finish.
- Preparation
- Decorative systems are unforgiving of a poor substrate, so walls are made genuinely flat and sealed with the base coat the system requires before any decorative layer is applied.
- Where it is offered
- Decorative & Custom is offered across Melbourne and surrounding suburbs, generally within about 40 km of Balwyn.
- Quoting
- Decorative & Custom is quoted in writing at no charge, after an inspection of the actual surfaces.
What we cover
Also included
Venetian plaster
Polished lime and acrylic plaster applied in thin layers and burnished to a stone-like surface with genuine depth and subtle movement.
Stucco and textured plaster
Heavier textured plaster finishes, from fine sand textures through to more pronounced trowelled surfaces.
Concrete-look finishes
Micro-cement and concrete-effect coatings that give the tonal variation of raw concrete without its weight or thickness.
Marble and stone effects
Hand-applied veining and tonal work that reads as stone at architectural scale, suited to feature walls and joinery surrounds.
Woodgrain effects
Grained finishes used to bring painted joinery, doors and panelling into keeping with timber elements elsewhere.
Metallic finishes
Metallic and pearlescent coatings that shift as light moves across them, used sparingly on a single surface for effect.
Chalkboard and writable walls
Writable and chalkboard surfaces for kitchens, studies, playrooms and commercial spaces.
Murals and hand-painted elements
Hand-painted feature work developed with you and produced to suit the architecture rather than sit against it.
Geometric and patterned designs
Set out and masked accurately so lines are true and the pattern resolves correctly at corners and edges.
The work
Decorative & Custom photos
Black curved feature wall against white Arched niche with a grey back wall Arched niches and reception walls
Our process
How the work runs
Step 1: Discuss the effect
What you want the surface to do — texture, depth, tone, how much movement — and where it sits in relation to the rest of the room.
Step 2: Sample
Sample boards prepared and viewed in the actual space at different times of day. Decorative finishes cannot be chosen from a photograph.
Step 3: Prepare the substrate
Decorative finishes are unforgiving of a poor surface. Walls are made genuinely flat and true, then primed with a base suited to the system.
Step 4: Base coats
The base colour and any build coats applied, since most decorative systems depend on what is underneath showing through.
Step 5: Apply and work the finish
The decorative layers applied by hand and worked while open — trowelled, burnished, dragged or stippled depending on the system.
Step 6: Seal and protect
Where the system requires it, a protective sealer is applied so the surface can be cleaned without damaging the finish.
Why it holds up
What you get
- Sampled in your own space before anything goes on the wall
- Substrate made genuinely flat, because decorative finishes reveal every flaw
- Finishes used sparingly and deliberately rather than everywhere
- Sealed where needed so the surface remains cleanable
Systems and materials
- Lime and acrylic-based polished plasters
- Micro-cement and concrete-effect systems
- Metallic, pearlescent and glaze coatings
- Textured and trowel-applied plaster systems
- Protective sealers appropriate to each finish
The specific products for your project are named in your written quote, so you know what is going on your property before you accept it.
Comparison
Venetian plaster compared with paint
The two are often priced against each other. They are different materials that behave differently, so the comparison is worth making properly.
| Venetian plaster | Standard paint | |
|---|---|---|
| What it is | A mineral material, traditionally lime-based, built up in thin trowelled layers | A pigmented film applied over the surface in one or two coats |
| Where the appearance comes from | Depth within the layers, which shifts as light moves across it | A uniform colour on the surface |
| Substrate demands | High. A polished finish shows every hollow and sanding mark behind it | Moderate. Minor imperfections are far less visible under a flat finish |
| Repairing damage | The surface is reworked, and a seamless patch is difficult | Touch-in is straightforward if the colour is recorded |
| Best used on | Feature walls, entries and stairwells where light rakes across the surface | Whole rooms, ceilings, trim and anywhere a consistent colour is wanted |
Applied to every wall in a room, a decorative finish tends to cancel itself out — the effect depends on contrast with plainer surfaces around it. That is why most schemes use one and not the other, rather than choosing between them for the whole house.
Worth knowing
Limitations and upkeep
Before committing to this work
- A polished finish reveals everything behind it. Walls that have been patched repeatedly, or that are still moving and cracking, need resolving before any decorative system is considered.
- Not every system suits a wet area. Where one is used in a bathroom or laundry it must be specified for that exposure and finished with the sealer the manufacturer requires.
- Surfaces taking heavy contact wear — hallway corners, commercial circulation routes — are generally better served by a durable painted finish.
- Colour and movement vary by hand and by batch. A sample panel made on site, in the actual light, is the only reliable way to agree the result in advance.
Afterwards
Decorative finishes are maintained differently from paint, and the difference matters most in the first few weeks.
- Allow the finish to cure fully before washing it. Lime-based systems continue to harden for some time after application.
- Clean with a soft dry cloth. Abrasive pads and household cleaners can burnish or dull a polished surface unevenly.
- Deal with a knock or a scuff sooner rather than later — reworking a small area is far easier than blending a large one.
- Keep a record of the system and the colour used. Matching a hand-applied finish years later without it is close to guesswork.
Questions
Common questions
If your question is not here, call and ask. We would rather explain it properly than have you guess.
Where do decorative finishes work best?
On a single surface that is meant to carry a room — an entry wall, a stairwell, a fireplace surround, a powder room, or joinery in an open-plan space. Used across every wall the effect is lost, and the room usually feels heavier than intended.
How is a decorative finish priced?
By the system, the area, the number of layers and the preparation the substrate needs. It is materially more expensive per square metre than standard painting because it is slower, more specialised hand work. We quote it after seeing the wall and agreeing the finish.
Can decorative finishes be cleaned?
Most can be wiped gently once sealed, but they are not as robust as a washable wall paint and abrasive cleaning will damage them. We will tell you how to look after the specific finish you choose.
Can Venetian plaster go in a bathroom?
Polished plaster is used in bathrooms, but it depends on the specific system, the level of direct water exposure and the sealer used. Splash zones and shower interiors need particular care and are not suited to every product, so we assess the room before recommending it.
Do you do murals?
Yes, developed with you for the specific space. The aim is work that suits the architecture and reads as a considered part of the interior.
Further reading
Before you decide
Longer answers to the questions this work usually raises. No sales pitch — just what we would tell you on site.
Where we work
Decorative & Custom across Melbourne
We work throughout Melbourne and surrounding suburbs, generally within about 40 km of the city. If your property sits outside that, ask — we travel for larger projects.
Balwyn · Brighton · Camberwell · Kew · Hawthorn · Malvern · Richmond · South Yarra · Toorak · Armadale · Canterbury · Surrey Hills
Explore
Related services
- Learn more
Interior Painting
Walls, ceilings, trim, doors and built-ins, finished cleanly in homes people are still living in.
- Learn more
Walls & Ceilings
Wall and ceiling repainting over repaired, sanded and primed surfaces, with crisp cut-in lines.
- Learn more
Colour Consultation
Help choosing a scheme that works in your light, on your surfaces and in your street.
- Learn more
Surface Preparation
Washing, crack repair, sanding, caulking, wallpaper removal, priming and sealing — the work a finish depends on.

Free, no-obligation quotes
Get a written quote for your painting job
Tell us what needs painting and send a few photos. We will inspect the property and put a written, itemised quote in front of you — in Australian dollars, with the scope spelled out.